Drop-Unsecure - Cisco Sx350 Cli Manual

29
619
switchxxxxxx(config-ra-guard)#

29.11 drop-unsecure

To enable dropping messages with no or invalid options or an invalid signature
within an IPv6 ND Inspection policy, use the drop-unsecure command in ND
Inspection Policy Configuration mode. To return to the default, use the no form of
this command.
Syntax
drop-unsecure [enable | disable]
no drop-unsecure
Parameters
• enable—Enables dropping messages with no or invalid options or an invalid
signature. If no keyword is configured this keyword is applied by default.
•
disable—Disables dropping messages with no or invalid options or an
invalid signature.
Default Configuration
Policy attached to port or port channel: the value configured in the policy attached
to the VLAN.
Policy attached to VLAN: global configuration.
Command Mode
ND inspection Policy Configuration mode
User Guidelines
If this command is part of a policy attached to a VLAN, it is applied to all the ports
in the VLAN. If it is defined in a policy attached to a port in the VLAN, this value
overrides the value in the policy attached to the VLAN.
exit
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IPv6 First Hop Security