Qos Wrr-Queue Wrtd - Cisco Sx350 Cli Manual

Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
no traffic-shape queue
Parameters
queue-id—Specifies the queue number to which the shaper is assigned.
(Range: 1-8 ).
•
committed-rate—Specifies the average traffic rate (CIR) in kbits per second
(kbps). (Range: 64 kbps–maximum port speed)
•
committed-burst—Specifies the excess burst size (CBS) in bytes. (Range:
4096 - 16762902 bytes)
Default Configuration
The shaper is disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
The egress port shaper controls the traffic transmit rate (Tx rate) on a queue on a
port.
Example
The following example sets a shaper on queue 1 on gi11 when the average traffic
rate exceeds 124000 kbps or the normal burst size exceeds 9600 bytes.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)#

47.24 qos wrr-queue wrtd

Use the qos wrr-queue wrtd Global Configuration mode command to enable
Weighted Random Tail Drop (WRTD). Use the no form of this command to disable
WRTD.
Syntax
qos wrr-queue wrtd
queue-id
traffic-shape queue 1 64 4096
47
944