Radius Commands; Radius-Server Host - Cisco Sx350 Cli Manual

RADIUS Commands

Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
48.0

48.1 radius-server host

Use the radius-server host Global Configuration mode command to configure a
RADIUS server host. Use the no form of the command to delete the specified
RADIUS server host.
Syntax
ip-address | hostname
radius-server host {
acct-port-number
[acct-port
deadtime key-string
] [key
encrypted radius-server host {
auth-port-number
] [acct-port
retries deadtime
] [deadtime
| |
{login dot1.x all}]
no radius-server host {
Parameters
•
ip-address
—Specifies the RADIUS server host IP address. The IP address
can be an IPv4, IPv6 or IPv6z address.
•
hostname
—Specifies the RADIUS server host name. Translation to IPv4
addresses only is supported. (Length: 1–158 characters. Maximum label
length of each part of the hostname: 63 characters)
•
auth-port-number
auth-port
requests. If the port number is set to 0, the host is not used for
authentication. (Range: 0–65535)
•
acct-port-number
acct-port
host is not used for accountings if set to 0. If unspecified, the port number
defaults to 1813.
•
timeout
timeout
} [auth-port
timeout
] [timeout
priority
] [priority ] [usage {login
ip-address | hostname
acct-port-number
encrypted-key-string
] [key
ip-address hostname
|
—Specifies the port number for authentication
—Port number for accounting requests. The
—Specifies the timeout value in seconds. (Range: 1–30)
48
auth-port-number
retries
] [retransmit ] [deadtime
| |
dot1.x all}]
} [auth-port
timeout
] [timeout ] [retransmit
priority
] [priority
}
]
] [usage
965