Show Lldp Local - Cisco Sx350 Cli Manual

Link Layer Discovery Protocol (LLDP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Field Description
Tx delay The delay between successive LLDP frame
transmissions initiated by value/status changes in the
LLDP local systems MIB.
Port The port number.
State The port's LLDP state.
Optional TLVs Optional TLVs that are advertised. Possible values are:
PD - Port description
SN - System name
SD - System description
SC - System capabilities
4W - 4 wire spare pair capability
Address The management address that is advertised.
Notifications Indicates whether LLDP notifications are enabled or
disabled.
Port VLAN ID advertised.
PVID
Protocol Port VLAN ID advertised.
PPVID
Protocols

36.24 show lldp local

To display the LLDP information that is advertised from a specific port, use the
show lldp local Privileged EXEC mode command.
Syntax
interface-id
show lldp local
Parameters
Interface-id—(Optional) Specifies a port ID.
Default Configuration
If no port ID is entered, the command displays information for all ports.
Command Mode
Privileged EXEC mode
36
784