Ipv6 Nd Prefix - Cisco Sx350 Cli Manual

IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Parameters
N/A.
Default Configuration
The Other Stateful configuration flag is not set in IPv6 router advertisements.
Command Mode
Interface Configuration mode
User Guidelines
The setting of the Other Stateful configuration flag in IPv6 router advertisements
indicates to attached hosts how they can obtain autoconfiguration information
other than addresses. If the flag is set, the attached hosts should use stateful
autoconfiguration to obtain the other (nonaddress) information.
Note. If the Managed Address Configuration flag is set using the
managed-config-flag
autoconfiguration to obtain the other (nonaddress) information regardless of the
setting of the Other Stateful configuration flag.
Example
The following example configures the Other Stateful configuration flag in IPv6
router advertisements on VLAN 1:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#

28.18 ipv6 nd prefix

Use the ipv6 nd prefix command in Interface Configuration mode to configure
which IPv6 prefixes are included in IPv6 Neighbor Discovery (ND) router
advertisements.
To remove the prefixes, use the no form of this command.
command, then an attached host can use stateful
interface vlan 1
ipv6 nd other-config-flag
exit
28
ipv6 nd
570