System Management Commands; Disable Ports Leds - Cisco Sx350 Cli Manual

System Management Commands

Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
62.0

62.1 disable ports leds

To turn off the LEDs on all ports on a device, use the disable ports leds Global
Configuration mode command.
To set the LEDs of all the ports on the device to their current operational status of
the port, use the no disable ports leds command.
Syntax
disable ports leds
no disable ports leds
Parameters
This command has no arguments or keywords.
Default Configuration
The default is no disable port leds; that is the LEDs of all the ports reflect their
current status.
Command Mode
Global Configuration mode
Examples
The following example turns off the port LEDs.
switchxxxxxx(config)# disable ports leds
62
1184