Cisco Sx350 Cli Manual page 771

Link Layer Discovery Protocol (LLDP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
To remove LLDP MED network policy, use the no form of this command.
Syntax
lldp med network-policy
untagged}] [up priority] [dscp value]
no lldp med network-policy
Parameters
•
number—Network policy sequential number. The range is 1-32.
•
application—The name or the number of the primary function of the
application defined for this network policy. Available application names are:
-
voice
-
voice-signaling
-
guest-voice
-
guest-voice-signaling
-
softphone-voice
-
video-conferencing
-
streaming-video
-
video-signaling.
•
vlan vlan-id —(Optional) VLAN identifier for the application.
•
vlan-type—(Optional) Specifies if the application is using a tagged or an
untagged VLAN.
•
priority
up —(Optional) User Priority (Layer 2 priority) to be used for the
specified application.
•
value
dscp —(Optional) DSCP value to be used for the specified application.
Default Configuration
No network policy is defined.
Command Mode
Global Configuration mode
number application [vlan vlan-id] [vlan-type {tagged |
number
36
770