Cdp Commands; Cdp Advertise-V2; Cdp Appliance-Tlv Enable - Cisco Sx350 Cli Manual

CDP Commands

Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
8.0
8.1

cdp advertise-v2

To specify version 2 of transmitted CDP packets, use the cdp advertise-v2
command in Global Configuration mode. To specify version 1, use the no form of
this command.
Syntax
cdp advertise-v2
no cdp advertise-v2
Parameters
N/A
Default Configuration
Version 2.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)#
switchxxxxxx(config)#
8.2

cdp appliance-tlv enable

To enable sending of the Appliance TLV, use the cdp appliance-tlv enable
command in Global Configuration mode. To disable the sending of the Appliance
TLV, use the no form of this command.
cdp run
cdp advertise-v2
8
208