Table of Contents
Advertisement
3
802.1X Commands
Command Mode
Global Configuration mode
User Guidelines
Any combination of the keywords are allowed. At least one keyword must be
configured.
A rate limit is applied to the traps: not more than one trap of this type can be sent in 10
seconds.
Example
The following example enables sending traps when a MAC address fails to be
by the 802.1X mac-authentication access control.
authorized
switchxxxxxx(config)#
dot1x traps authentication failure 802.1x
3.27 dot1x traps authentication quiet
To enable sending traps when a host state is set to the quiet state after failing the
maximum sequential attempts of login, use the dot1x traps authentication quiet
command in Global Configuration mode. To disable the traps, use the no form of
this command.
Syntax
dot1x traps authentication quiet
no dot1x traps authentication quiet
Parameters
N/A
Default Configuration
Quiet traps are disabled.
Command Mode
Global Configuration mode
109
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Advertisement
Table of Contents
