Show Cdp Entry - Cisco Sx350 Cli Manual

8
221
Device-ID TLV (0x0001
Address TLV (0x0002)
Port-ID TLV (0x0003)
Capabilities TLV (0x0004)
Version TLV (0x0005)
Platform TLV (0x0006)
Sending CDPv2 advertisements is enabled
Sending Appliance TLV is enabled
Device ID format is Serial Number
Sending CDP packets every 60 seconds
Sending a holdtime value of 180 seconds

8.17 show cdp entry

To display information about specific neighbors, use the show cdp entry
command in Privileged EXEC mode.
Syntax
show cdp entry {* | device-name}
Parameters
•
*—Specifies all neighbors
•
device-name—Specifies the name of the neighbor.
•
protocol—Limits the display to information about the protocols enabled on
neighbors.
•
version—Limits the display to information about the version of software
running on the neighbors.
Default Configuration
Version
Command Mode
Privileged EXEC mode
Example
[protocol | version]
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
CDP Commands