Table of Contents
Advertisement
4
125
Example
The following example enables bridge Multicast filtering.
switchxxxxxx(config)#
4.2
bridge multicast mode
To configure the Multicast bridging mode, use the bridge multicast mode Interface
(VLAN) Configuration mode command. To return to the default configuration, use
the no form of this command.
Syntax
bridge multicast mode
no bridge multicast mode
Parameters
•
mac-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC address.
•
ipv4-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC address for non-IPv4 packets, and on the packet's VLAN
and IPv4 destination address for IPv4 packets.
•
ipv4-src-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC address for non-IPv4 packets, and on the packet's VLAN,
IPv4 destination address and IPv4 source address for IPv4 packets.
Default Configuration
The default mode is mac-group.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use the mac-group option when using a network management system that uses a
MIB based on the Multicast MAC address. Otherwise, it is recommended to use
bridge multicast filtering
{
|
mac-group
ipv4-group
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Address Table Commands
|
}
ipv4-src-group
Advertisement
Table of Contents
