Cdp Run - Cisco Sx350 Cli Manual

CDP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Command Mode
Global Configuration mode
User Guidelines
When CDP is globally enabled, CDP packets are filtered (discarded) on
CDP-disabled ports.
In the flooding mode, VLAN filtering rules are not applied, but STP rules are
applied. In case of MSTP, the CDP packets are classified to instance 0.
Example
switchxxxxxx(config)#
switchxxxxxx(config)#

8.11 cdp run

To enable CDP globally, use the cdp run command in Global Configuration mode.
To disable CDP globally, use the no form of this command.
Syntax
cdp run
no cdp run
Parameters
N/A
Default Configuration
Enabled.
Command Mode
Global Configuration mode
User Guidelines
CDP is a link layer protocols for directly-connected CDP/LLDP-capable devices to
advertise themselves and their capabilities. In deployments where the CDP/LLDP
capable devices are not directly connected and are separated with CDP/LLDP
cdp run
cdp pdu flooding
8
216