Sntp Broadcast Client Enable - Cisco Sx350 Cli Manual

Clock Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Default Configuration
No authentication key is defined.
Command Mode
Global Configuration mode
Examples
The following example defines the authentication key for SNTP.
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#
switchxxxxxx(config)#

9.11 sntp broadcast client enable

To enable SNTP Broadcast clients, use the sntp broadcast client enable command
in Global Configuration mode. To restore the default configuration, use the no form
of this command.
Syntax
sntp broadcast client enable [both | ipv4 | ipv6]
no sntp broadcast client enable
Parameters
•
both—(Optional) Specifies the IPv4 and IPv6 SNTP Broadcast clients are
enabled. If the parameter is not defined it is the default value.
•
ipv4—(Optional) Specifies the IPv4 SNTP Broadcast clients are enabled.
•
ipv6—(Optional) Specifies the IPv6 SNTP Broadcast clients are enabled.
Default Configuration
The SNTP Broadcast client is disabled.
sntp authentication-key
sntp authentication-key 8 md5 ClkKey
sntp trusted-key 8
sntp authenticate
8 md5 ClkKey
9
248