Ipv6 Access-List (Ip Standard) - Cisco Sx350 Cli Manual

2
79
Example 3 - To specify a large number of individual addresses more easily, you
can omit the mask length if it is 32. Thus, the following two configuration
commands are identical in effect:
switchxxxxxx(config)# ip access-list 2aa permit 10.48.0.3
switchxxxxxx(config)# ip access-list 2aa permit 10.48.0.3/32

2.21 ipv6 access-list (IP standard)

The ipv6 access-list Global Configuration mode command defines an IPv6
standard list. The no format of the command removes the list.
Syntax
access-list-name
ipv6 access-list
access-list-name
no ipv6 access-list
Parameters
•
access-list-name—The name of the Standard IPv6 access list. The name
may contain maximum 32 characters.
•
deny—Denies access if the conditions are matched.
•
permit—Permits access if the conditions are matched.
•
src-addr src-len
[/
or any. The any value matches to all IPv6 addresses. If the
defined a value of 128 is applied. A value of
1-128.
Default Configuration
no access list
Command Mode
Global Configuration mode
User Guidelines
Use the ipv6 access-list command to configure IPv6 address filtering. Access lists
are configured with permit or deny keywords to either permit or deny an IPv6
address based on a matching condition. An implicit deny is applied to address that
does not match any access-list entry.
{deny| p ermit} {
] | any— IPv6 prefix defined as an IPv6 address and length
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
ACL Commands
src-addr src-len
[/ ] | any}
src-len
src-len
must be in interval
is not