How To Configure An Ipv6 Router Advertisement Guard Policy - Cisco Catalyst 2960-XR Security Configuration Manual

How to Configure an IPv6 Router Advertisement Guard Policy

Command or Action
Step 4
do show running-config
Example:
Switch#(config-if)#
How to Configure an IPv6 Router Advertisement Guard Policy
Beginning in privileged EXEC mode, follow these steps to configure an IPv6 Router Advertisement policy :
SUMMARY STEPS
1. configure terminal
2. [no]ipv6 nd raguard policy policy-name
3. device-role {host | monitor | router | switch}
4. hop-limit {maximum | minimum} value
5. managed-config-flag {off | on}
6. match {ipv6 access-list list | ra prefix-list list}
7. other-config-flag {on | off}
8. router-preference maximum {high | medium | low}
9. trusted-port
10. default {device-role | hop-limit {maximum | minimum} | managed-config-flag | match {ipv6 access-list
| ra prefix-list } | other-config-flag | router-preference maximum| trusted-port}
11. no {device-role | hop-limit {maximum | minimum} | managed-config-flag | match {ipv6 access-list |
ra prefix-list } | other-config-flag | router-preference maximum| trusted-port}
12. do show ipv6 nd raguard policy policy_name
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Switch# configure terminal
Step 2 [no]ipv6 nd raguard policy policy-name
Example:
Switch(config)# ipv6 nd raguard policy example_policy
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
362
do show running-config
Purpose
Confirms that the policy is attached to the specified VLANs
without exiting the configuration mode.
Purpose
Enters the global configuration mode.
Specifies the RA Guard policy name and enters RA
Guard Policy configuration mode.
Configuring IPv6 First Hop Security
OL-29434-01