Epson S1C17F13 Technical Manual page 15

1 OVERVIEW
Timers
Watchdog timer (WDT)
16-bit timer (T16)
Clock timer (CT)
Real-time clock (RTC)
Theoretical regulation function (TR)
16-bit PWM timer (T16A3)
Supply voltage detector (SVD)
Detection level
Other
R/F converter (RFC)
Conversion method
Number of conversion channels
Supported sensors
Temperature detection circuit (TEM)
Resolution/accuracy
Reset
#RESET pin
Power-on reset
Brownout reset
Key entry reset
Watchdog timer reset
Supply voltage detector reset
Interrupt
Non-maskable interrupt
Programmable interrupt
Power supply voltage
V operating voltage
DD
Operating temperature
Operating temperature range
Current consumption
SLEEP mode
HALT mode
RUN mode
Shipping form
1
2
*1 When using the EPD timing controller (EPD Tcon), an area for storing the timing parameters must be allocated in the Flash memory.
When using the internal Flash voltage booster as the Flash programing power supply, an area for storing the control program
must be allocated in the Flash memory.
1-2
1 channel
Generates NMI or watchdog timer reset.
4 channels
Generates the SPI master clocks. (Ch.1 to Ch.3)
1 channel
128–1 Hz counter
Hour, minute, and second counters
Time adjustment function in -31/32,768 to +32/32,768 second units (applied to T16A3,
CT, and RTC clocks)
Supports correction value alteration according to temperature variations.
2 channels
PWM output, event counter, and count capture functions
19 values (1.8 to 3.6 V)
Intermittent operation mode
Generates an interrupt or reset according to the detection level evaluation.
CR oscillation type with 24-bit counters
2 channels (Up to four sensors can be connected.)
DC-bias resistive sensors and AC-bias resistive sensors
1 °C steps, ±5 °C accuracy
Reset when the reset pin is set to low.
Reset at power-on.
Reset when brownout (V = 1.45 V typ.) is detected.
DD
Reset when the P00 to P01/P02/P03 keys are pressed simultaneously (can be en-
abled/disabled using a register).
Reset when the watchdog timer overflows (can be enabled/disabled using a register).
Reset when the supply voltage detector detects the set voltage level (can be enabled/
disabled using a register).
4 systems (Reset, address misaligned interrupt, debug, NMI)
External interrupt: 1 system (8 levels)
Internal interrupt: 19 systems (8 levels)
2.0 to 3.6 V
-20 to 70 °C
0.35 µA
OSC1 = OFF, RTC = OFF, OSC3B = OFF, OSC3A = OFF
0.78 µA
OSC1 = 32 kHz (OSC1A), RTC = OFF, OSC3B = OFF, OSC3A = OFF
0.80 µA
OSC1 = 32 kHz (OSC1A), RTC = ON, OSC3B = OFF, OSC3A = OFF
11.9 µA
OSC1 = 32 kHz (OSC1A), RTC = OFF, OSC3B = OFF, OSC3A = OFF
5.43 mA
OSC1 = OFF, RTC = OFF, OSC3B = OFF, OSC3A = 20 MHz ceramic
5.50 mA
OSC1 = OFF, RTC = OFF, OSC3B = 20 MHz, OSC3A = OFF
TQFP13-64pin (Lead pitch: 0.5 mm)
Chip (Pad pitch: 90 µm)
Seiko epson Corporation
S1C17F13 TeChniCal Manual
(Rev. 1.0)