Setting Up Print Server For Windows Nt - Agilent Technologies 4155C User Manual

Table 3-8
Step 1.
Step 2.
Figure 3-15

Setting Up Print Server for Windows NT

This section describes how to set up a print server using the computer installed with
Windows NT. Before starting the procedure, set up the network of the computer as
described in "Setting Up Network for Windows NT" on page 3-30.
Check List of Setting up Print Server
Steps
Step 1. Preparation
Step 2. Network Services
Step 3. Services
Step 4. Add Printer
Preparation
1. Log on to Windows.
2. Click Start, Settings, and Control Panel to open the Control Panel.
Network Services
1. Double-click the Network icon to open the Network dialog box.
2. Click the Services tab of the Network dialog box. See Figure 3-15.
3. If Microsoft TCP/IP Printing is not installed, click Add. After that, follow the
setup instructions to install the TCP/IP Printing service.
4. Click OK.
Confirming Network Services
Network
TCP/IP Printing
xxxx
xxxx
3
Add
4
OK
Agilent 4155C/4156C User's Guide Vol.1, Edition 11
You open Control Panel.
You check network services.
You enable TCP/IP Print Server.
You register a printer in the print server.
2
Services Tab
3 To add the TCP/IP printing service
Connecting to Network
If You Use a Windows PC
Summary
Select Network Service
xxxx
Microsoft TCP/IP Printing
OK
3-33