Agilent Technologies 4155C User Manual page 168

Print/Plot Function
Printing/Plotting Measurement Data Lists
4. To set the OUTPUT DATA (INDEX NO) to be printed/plotted:
a. Select the data INDEX numbers 1 to 100, entering the following:
*OUTPUT DATA (INDEX NO)
1 <-->
b. Select all measurement data by selecting ALL softkey.
5. To set the OUTPUT REGION, enter the following entry fields.
UPPER LEFT
LOWER RIGHT
Select one of the following softkeys, or enter a value using the keyboard or the
ENTRY keys on the front panel. These softkeys are available for each OUTPUT
REGION field:
WHOLE
UPPER LEFT
UPPER RIGHT
LOWER LEFT
LOWER RIGHT
STORE REGION
RECALL REGION Recalls the latest settings stored in the internal memory.
To set the output region to the upper half of the paper, the OUTPUT REGION
should be defined as follows:
*OUTPUT REGION
UPPER LEFT
LOWER RIGHT
6. Optional: Enter a comment of up to 58 characters in the PRINT/PLOT
COMMENT field. This comment is printed only when this field is enabled on
the SYSTEM: PRINT/PLOT SETUP screen.
7. To start printing/plotting, select PRINT/PLOT softkey.
8. To close the PRINT/PLOT DATA LIST dialog box, select EXIT softkey.
5-16
100
Specifies the position of the upper-left corner of the printed
or plotted hard copy.
Specifies the position of the lower-right corner of the
printed or plotted hard copy. (If you set the LANGUAGE to
PCL or HR PCL, ignore the LOWER RIGHT field.)
Sets the output region as the entire sheet.
Sets the output region to the upper-left quarter of the
paper.
Sets the output region to the upper-right quarter of the
paper.
Sets the output region to the lower-left quarter of the
paper.
Sets the output region to the lower-right quarter of the
paper.
Stores the OUTPUT REGION settings in the internal
memory.
X 0% Y 0%
X 100% Y 50%
Agilent 4155C/4156C User's Guide Vol.1, Edition 11
<--origin of printer