Agilent Technologies 4155C User Manual page 106

Step 3.
Step 4.
Step 5.
Connecting to Network
If You Use a Windows PC
3. Click Performance and Maintenance, then System to open the System Properties
dialog box.
4. Click the Computer Name tab.
5. Check Full computer name and Workgroup or Domain. Or set them properly.
Network Protocols
1. In the Control Panel, click Network and Internet Connections, then Network
Connections.
2. Double-click Local Area Connection to open the Local Area Connection Status
dialog box.
3. Click Properties to open the Local Area Connection Properties dialog box.
If Internet Protocol (TCP/IP) is not installed, click Install. After that, step
through the setup instruction to install the TCP/IP.
4. Highlight Internet Protocol (TCP/IP).
TCP/IP Properties
1. Click Properties to open the Internet Protocol (TCP/IP) Properties dialog box.
2. If you are going to use the DHCP server, click "Obtain an IP address
automatically". You do not need to set the network parameters.
Otherwise, click "Use the following IP address" and set the network parameters.
3. Click OK.
4. Click OK.
5. Click Close.
Network Connection Check
1. Click Start, All Programs, Accessories, and Command Prompt to open the
Command Prompt window.
2. Ping a computer or a device on the network. If, for example, the IP address of
the device is 192.168.1.99, execute C:\> ping 192.168.1.99.
If any error occurs, perform these instructions again.
3-22 Agilent 4155C/4156C User's Guide Vol.1, Edition 11