Agilent Technologies 4155C User Manual page 187

5. If you select HR PCL, HR TIFF or HP-GL, set the GRAPH TRACE ONLY field
by selecting YES or NO softkey.
YES
NO
6. Set the PRINT SETUP DATA field by selecting YES or NO softkey.
YES
NO
If you select YES, set the POSITION entry field. (For the PCL mode, the
POSITION field is not displayed and is always set to BOTTOM.)
BOTTOM
RIGHT
7. If you select HR PCL or HP-GL, set the OUTPUT REGION. There are two
available fields:
UPPER LEFT
LOWER RIGHT
Select one of the following softkeys, or enter a value using the keyboard or the
ENTRY keys on the front panel. These softkeys are available for each OUTPUT
REGION field:
WHOLE
UPPER LEFT
UPPER RIGHT
LOWER LEFT
LOWER RIGHT
STORE REGION
RECALL REGION Recalls the latest settings stored in the internal memory.
Agilent 4155C/4156C User's Guide Vol.1, Edition 11
Saving Measurement Data Graphs
Graph trace only output.
Outputs the graph information enabled on PRINT/PLOT
SETUP screen OUTPUT ITEM fields.
Graph output with setup data.
Graph output only.
Places the setup data below the graph.
Places the setup data to the right of the graph.
Specifies the position of the upper-left corner of the printed
or plotted hard copy.
Specifies the position of the lower-right corner of the
printed or plotted hard copy.
Sets the output region as the entire sheet.
Sets the output region to the upper-left quarter of the
paper.
Sets the output region to the upper-right quarter of the
paper.
Sets the output region to the lower-left quarter of the
paper.
Sets the output region to the lower-right quarter of the
paper.
Stores the OUTPUT REGION settings in the internal
memory.
Print/Plot Function
5-35