Setting Up Network For Windows 2000 - Agilent Technologies 4155C User Manual

NOTE
Table 3-5
Step 1.

Setting Up Network for Windows 2000

If your computer has already been on the network, ignore this section. Just check the
following network parameters.
• Computer name
• IP address of the computer
• IP address of the gateway (optional)
• Subnet mask (optional)
You can check these values by executing the hostname command and the ipconfig
command using the Command Prompt.
This section describes how to set up the network of the computer.
Check List of Network Setup
Steps
Step 1. Preparation
Step 2. Network Identification
Step 3. Network Protocols
Step 4. TCP/IP Properties
Step 5. Network Connection Check
Preparation
1. Set up the computer, and connect the CD-ROM drive to the computer.
2. Connect the computer to the network of your site using the straight LAN cable.
If you are not going to connect the computer to the network but to the
4155C/4156C directly, use the cross LAN cable.
3. Turn on the computer and CD-ROM drive. Then wait until Windows boots up.
Agilent 4155C/4156C User's Guide Vol.1, Edition 11
Connecting to Network
If You Use a Windows PC
Summary
You set up the computer.
You check the network identification.
You set the network protocol.
You set up the TCP/IP properties.
You check the network connection.
3-25