Agilent Technologies 4155C User Manual page 110

Step 2.
Step 3.
Figure 3-10
Connecting to Network
If You Use a Windows PC
Network Identification
1. Log on to Windows.
2. Click Start, Settings, and Control Panel to open the Control Panel.
3. Double-click the System icon to open the System Properties dialog box.
4. Click the Network Identification tab.
5. Check Full computer name and Workgroup or Domain. Or set them properly.
Network Protocols
1. Double-click the Network and Dial-up Connections icon in the Control Panel.
2. Double-click the Local Area Connection icon to open the Local Area
Connection Status dialog box. See Figure 3-10.
3. Click Properties to open the Local Area Connection Properties dialog box.
4. If Internet Protocol (TCP/IP) is not installed, click Install. After that, step
through the setup instruction to install the TCP/IP.
5. Highlight Internet Protocol (TCP/IP).
Selecting Network Protocol
Network and Dial-up
2
Local Area
Connection
3-26
Local Status
Connection
Activity
3
Properties
Agilent 4155C/4156C User's Guide Vol.1, Edition 11
Local Properties
Connect using:
Components
xxxx
xxxx
TCP/IP
4
Install
5