Setting Up Print Server For Windows 2000 - Agilent Technologies 4155C User Manual

Table 3-6
Step 1.
Step 2.
Connecting to Network
If You Use a Windows PC

Setting Up Print Server for Windows 2000

This section describes how to set up a print server using the computer installed with
Windows 2000. Before starting the procedure, set up the network of the computer as
described in "Setting Up Network for Windows 2000" on page 3-25.
Check List of Setting up Print Server
Steps
Step 1. Preparation
Step 2. Add/Remove Programs
Step 3. Services
Step 4. Add Printer
Preparation
1. Log on to Windows.
2. Click Start, Settings, and Control Panel to open the Control Panel.
Add/Remove Programs
1. Double-click the Add/Remove Programs icon to open the Add/Remote
Programs window.
2. Click Add/Remove Windows Components to open the Windows Components
Wizard. See Figure 3-12.
3. In the Components list box, highlight Other Network File and Print Services (but
do not select or clear its check box).
4. Click Details to open the Other Network File and Print Services window.
5. Confirm the Print Services for Unix check box.
If the check box has been selected (checked), click Cancel of the window, and
click Cancel of the wizard.
If the check box has not been selected, select the check box, click OK of the
window, click Next of the wizard. After that, step through the setup instruction
to install the Print Services for Unix.
6. Click Close of the Add/Remote Programs window.
3-28
You open Control Panel.
You check print services.
You enable TCP/IP Print Server.
You register a printer in the print server.
Agilent 4155C/4156C User's Guide Vol.1, Edition 11
Summary