Agilent Technologies 4155C User Manual page 116

Step 4.
Step 5.
Figure 3-14
5
Connecting to Network
If You Use a Windows PC
TCP/IP Properties
1. Click Properties to open the TCP/IP Properties dialog box. See Figure 3-14.
2. If the computer is installed with multiple network adapters, select one to use.
3. If you are going to use the DHCP server, click "Obtain an IP address from a
DHCP server". You do not need to set the network parameters.
Otherwise, click "Specify an IP address" and set the network parameters.
4. Click OK.
5. Click OK.
6. Restart the computer.
Network Connection Check
1. Log on to Windows.
2. Click Start, Programs, and Command Prompt to open the Command Prompt
window.
3. Ping a computer or a device on the network. If, for example, the IP address of
the device is 192.168.1.99, execute C:\> ping 192.168.1.99.
If any error occurs, perform these instructions again.
Setting up TCP/IP Properties
Network
TCP/IP Protocol
xxxx
xxxx
1
Properties
OK
3-32
TCP/IP Properties
IP Address Tab
3
4
Agilent 4155C/4156C User's Guide Vol.1, Edition 11
Adapter
xx Adapter 2
Obtain from DHCP
Specify IP address Example:
192.168.
IP Address
Subnet Mask
255.255.255. 0
Gateway
192.168.
OK
1. 1
1. 3