NOTE
Table 3-7
Connecting to Network
If You Use a Windows PC
Setting Up Network for Windows NT
If your computer has already been on the network, ignore this section. Just check the
following network parameters.
•
Computer name
•
IP address of the computer
•
IP address of the gateway (optional)
•
Subnet mask (optional)
You can check these values by executing the hostname command and the ipconfig
command using the Command Prompt.
This section describes how to set up the network of the computer.
Check List of Network Setup
Steps
Step 1. Preparation
Step 2. Network Identification
Step 3. Network Protocols
Step 4. TCP/IP Properties
Step 5. Network Connection Check
3-30
You set up the computer.
You check the network identification.
You set the network protocol.
You set up the TCP/IP properties.
You check the network connection.
Agilent 4155C/4156C User's Guide Vol.1, Edition 11
Summary