Agilent Technologies 4155C User Manual page 171

In this dialog box, three softkeys are available:
PRINT/PLOT
PR/PL SETUP
EXIT
2. To set the DESTINATION to the PRINTER/PLOTTER, select
PRINTER/PLOTTER softkey.
3. To set the LANGUAGE, select PCL, HR PCL, or HP-GL softkey.
If you select the PCL or HR PCL mode, set RESOLUTION by selecting one
softkey: 75 DPI to 600 DPI. For more information on selecting resolution, see
"Output Resolution" on page 5-5.
If you select the HR PCL mode, setting the resolution too low will result in poor
print quality.
4. If you select HR PCL or HP-GL, set the GRAPH TRACE ONLY field by
selecting YES or NO softkey.
YES
NO
5. Set the PRINT SETUP DATA field by selecting YES or NO softkey.
YES
NO
If you select YES, set the POSITION entry field. (For PCL, the POSITION field
is not displayed and is always set to BOTTOM.)
BOTTOM
RIGHT
6. If you select HR PCL or HP-GL, set the OUTPUT REGION. There are two
available fields:
UPPER LEFT
LOWER RIGHT
Agilent 4155C/4156C User's Guide Vol.1, Edition 11
Printing/Plotting Measurement Data Graphs
Executes the printing/plotting.
Displays the PRINT/PLOT SETUP screen. To close the
PRINT/PLOT SETUP screen, select EXIT softkey.
Closes the GRAPH PLOT dialog box and quits the
print/plot function.
Graph trace only output.
Outputs the graph information enabled on PRINT/PLOT
SETUP screen OUTPUT ITEM fields.
Graph output with setup data.
Graph output only.
Places the setup data below the graph.
Places the setup data to the right of the graph.
Specifies the position of the upper-left corner of the printed
or plotted hard copy.
Specifies the position of the lower-right corner of the
printed or plotted hard copy.
Print/Plot Function
5-19