Table of Contents
Advertisement
Conventional Brake Components
Front Brake Pads Inspection and Replacement
A C A U T I O N
Frequent inhalation of brake pad dust, regardless of
material composition, could be hazardous to your
health.
• Avoid breathing dust particles.
• Never use an air hose or brush to clean brake
assemblies. Use an OSHA-approved vacuum
cleaner.
1. Loosen the front wheel nuts slightly. Raise the front
of the vehicle, and make sure it is securely
supported. Remove the front wheels.
2. Remove the brake hose mounting bolts (A) from
the knuckle.
A
9.8
N m
(1.0 k g f m , 7.2 Ibfft)
3. Remove pin A (B) and pivot the caliper (C) up out of
the way. Check the hoses and pin boots for damage
and deterioration.
4. Remove the pad shims (A), pad retainers (B), and
pads (C).
A
C
5. Using vernier calipers, measure the thickness of
each brake pad lining. The measurement does not
include pad backing plate (A) thickness.
Brake Pad Thickness:
Standard:
1 0 . 5 - 1 1 . 5 mm (0.41 - 0 . 4 5 in.)
Service Limit: 1.6 mm (0.06 in.)
6. If the brake pad thickness is less than the service limit,
replace the front pads as a set.
7. Clean the caliper thoroughly; remove any rust, and
check for grooves and cracks.
S. Check the brake disc for damage and cracks.
9. Install the pad retainers (A).
19-10
Advertisement
Table of Contents
Troubleshooting
