Basic Operation; Installing/Removing The Front Bezel; Power On - NEC Bull NovaScale R620 User Manual

BASIC OPERATION

This section describes basic operation procedures of NovaScale/ft Server series.

Installing/removing the front bezel

When you power on/off the server, operate the CD-ROM drive, or remove/install a hard disk drive or CPU/IO module,
remove the front bezel.
IMPORTANT:
Front bezel cannot be opened without inserting the attached security key into the slot to release the lock.
1.
Insert the security key into the slot and turn it left with a little pressure to release the lock.
2.
Hold the right side of the front bezel lightly and pull it toward you.
3.
Detach the front bezel from the main unit by sliding it to the left a little to disengage the tabs from the frame.
To attach the front bezel, engage the tabs on the frame on the left side of the main unit. After attaching and
closing the front bezel, lock it with the key for security.

Power ON

To power on NovaScale/ft Server series, press the POWER switch located on the right of the front panel.
Follow the steps below to turn on the power.
1.
Power on the display unit and other peripheral devices connected to the server.
NovaScale R620 User Guide
2-23