Select New Tool - Siemens SINUMERIK 840D Operator's Manual

5
Parameters Operating Area
5.3 Tool management
(Names assigned by
user)
Maglist 1
Maglist 2
Maglist 3
Tool
details
Buffer on Buffer off
or
Find &
position
Next
magazine

5.3.2 Select new tool

Tool mana-
gement
Magazine
Tool list
list
or
Next
magazine
5-144
Vertical softkeys
Selection of user-specific windows (if configured), e.g.
•
General data
•
Geometry tool data
•
Wear data
Display and edit the tool offset data for a tool.
Display and skip the buffer window in the magazine list. The display
shows spindles, grippers, etc., i.e. locations which can accommodate
tools but which are not magazine locations.
You can use this softkey to find a tool or tool location in the active tool
magazine and position the tool. The tool is moved to the loading point.
Advance to the next magazine.
Function
If you want to load or unload a tool to/from a magazine, alter or re-edit
the current tool data or create a new tool edge, you must first select
the appropriate tool in the "Magazine list" or "Tool list".
Operating sequence
Select softkey "Tool management".
The horizontal and vertical softkey bars change.
Select the menu via the softkey
"Magazine list" or "Tool list".
Select the appropriate magazine.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5
03.04
 Siemens AG, 2004. All rights reserved