Configure The "New Tool - Favorites" Window; Configure Tool Types - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring tool management

13.7 Configure the "New tool - favorites" window

13.7 Configure the "New tool - favorites" window
Specify the most frequently used tool types in the
<NEWTOOLFAVORITESCONFIGURATION> tag.
The specified tool types are displayed in the "New Tool - Favorites" window
Entries
StaticTooltypes
Example
13.8

Configure tool types

The entries used for configuring the tool types are located in the
<TOOLTYPCONFIGURATION> tag.
Entries
TOOLTYPE_XXX
Tooltype
Name
Shortname
Tooltip
98
Meaning
Numbers of tool types Enter the individual numbers, separated by blanks.
The following section describes the assignment of the tool type and
number: List of tool types (Page 94)
Meaning
XXX stands for the number of the tool type.
The assignment of the tool type and number can be found in the"List of tool
types" section. List of tool types (Page 94)
Number (XXX) of the tool type
Text identifier of the tool name. The tool name is displayed in the following
windows:
"New Tool - Favorites"
•
"New Tool - Milling Cutter 100 - 199"
•
"New Tool - Drill 200 - 299"
•
"New Tool - Special Tool 700-900
•
See example: For the text identifier TM_PAR_SHANK_END_CUTTER, the
name "End mill" appears on the user interface.
Text identifier of the tool name. Tool name is displayed in the tool list.
See example: For the text identifier TM_PPTT_ SHANK_END_CUTTER, the
name "MILLING CUTTER" appears on the user interface.
Text identifier of the tool name. This tool name is displayed in the tooltip.
See example: For the text identifier TM_TTTT_ SHANK_END_CUTTER, the
name "End mill" appears on the user interface.
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
HMI sl (IM9)