Download  Print this page

Load Or Unload Tool In Magazine - Siemens SINUMERIK 840D Operator's Manual

Computerized numerical control system for machine tools.
Hide thumbs


Parameters Operating Area
5.4 ShopMill tool management

5.4.13 Load or unload tool in magazine

Machine manufacturer
Load a tool into the
Loading and unloading of tools into and out of magazine locations
must be enabled in a machine data code.
You can unload tools in the magazine that you are not using at
present. ShopMill then automatically saves the tool data in the tool list
outside the magazine. If you want to use the tool again later, simply
load the tool with the tool data into the corresponding magazine
location again. Then the same tool data does not have to be entered
more than once.
Please follow the machine manufacturer's instructions!
Operating sequence
Place the cursor on the tool that you want to load into the magazine (if
the tools are sorted according to magazine location number you will
find it at the end of the tool list).
Press the "Load" softkey.
The "Empty location" window appears. The "Location" field is
initialized with the number of the first empty magazine location.
Press the "OK" softkey to load the tool into the suggested location.
Enter the location number you require and press the "OK" softkey.
Enter the location number you require and press the "OK" softkey.
Press the "Spindle" and "OK" softkeys to load a tool into the spindle.
The tool is loaded into the specified magazine location.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
 Siemens AG, 2004. All rights reserved


Comments to this Manuals

Symbols: 0
Latest comments: