Download  Print this page

Edit Programs - Siemens SINUMERIK 840D Operator's Manual

Computerized numerical control system for machine tools.
Hide thumbs

Advertisement

6
Program Operating Area

6.4 Edit programs

New
Copy
Insert
Delete
Rename
Change
enable
Workpiece
Program
selection
selection
Back
6.4
Edit programs
6.4.1 Text editor
6-202
Vertical softkeys
Creates a new file for a workpiece/part program.
The current file name including the directory is marked and copied to
the clipboard. If you delete the copied file from the clipboard, you will
not be able to paste it again.
Pastes a file copied to the clipboard into the current directory; the file
name must be altered and confirmed beforehand.
Deletes a file (workpiece/part program).
Overwrites the file name/type of a workpiece/part program.
Sets/resets the enable for a workpiece/part program.
The enable must be set (X) for a workpiece/part program to be
selected.
Selects a workpiece/part program for execution in the currently active
channel.
When you branch to a workpiece, the "Back" softkey is displayed to
allow you to return to the workpiece overview.
The ASCII editor provides you with the following functions:
Switch between insert and overwrite mode.
Mark, copy, delete block.
Paste block.
Position cursor/find/replace text.
Create contour (programming support).
Configure cycle parameters (drilling, milling, turning).
Start simulation.
Recompile (cycles, free contour programming).
Renumber blocks.
Change settings.
For a detailed description, please refer to:
Chapter 2, "General operating sequences".
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
6
03.04
 Siemens AG, 2004. All rights reserved

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: