Download  Print this page

Siemens SINUMERIK 840D Operator's Manual Page 297

Computerized numerical control system for machine tools.
Hide thumbs

Advertisement

9
03.04
Machine
data
NC
PLC
HMI
Logical
drivers
LCD
LCD
brighter
darker
Change
language
NCK
Reset
Set
password
Delete
password
Change
password
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Horizontal softkeys
Enables you to change the machine data for all areas.
Here you can look at the NC settings for NC power up, the NC
address and NCU switchover and change them if necessary.
The function PLC status is available.
You can update date and time of the PLC and HMI.
Here you can enter the basic settings for the operator panel front (e.g.
color settings).
You can select the configuration screens for the new network by
activating the "Logical drives" softkey.
The "Logical drives" can refer to either a network connection or an
internal drive, e.g. a disk drive, a compact flash card etc.
Vertical softkeys
Only for OP 010 with STN display:
You can change the screen brightness.
You can use two languages in parallel.
When you select softkey "Change language", the screen text is
displayed in the other language.
If the language is not loaded, "?" is output. When you select softkey
"Change language" again, the text display reverts back to the other
language.
You can press this softkey to initiate NCK power ON/Reset.
You can set a password.
You can delete a password.
You can change your password.
Start-Up Operating Area
9.1 Start-up basic display
9
9-297

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: