Download  Print this page

General Functions And Displays - Siemens SINUMERIK 840D Operator's Manual

Computerized numerical control system for machine tools.
Hide thumbs

Advertisement

4
03.04
4.2

General functions and displays

4.2.1 Start/stop/abort/continue part program
Cycle Start
Cycle Stop
Reset
Repos
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
4.2 General functions and displays
Function
The following section describes how to start and stop part programs
and to resume them after they have been aborted.
Operating sequence
"AUTO" mode is selected in the "Machine" operating area.
Precondition:
No alarms are pending.
The program is selected.
Feedrate enable is active.
Spindle enable is set.
Start part program:
The part program is started and executed.
Stop/abort part program:
The program run is interrupted, but can be restarted with "Cycle Start"
The current program is aborted.
Resume part program:
After a program interruption ("Cycle Stop") you can retract the tool in
manual mode ("Jog") from the contour. The control saves the
coordinates of the point of interruption. The distances traversed by the
axes are displayed.
Repositioning:
Select the "Machine" operating area.
Select "Jog" mode.
Press the "Repos" key to reposition the tool on the contour.
Machine Operating Area
4
4-73

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: