Program Control Display - Siemens SINUMERIK 840D Operator's Manual

2
Operator Components/Operating Sequences
2.4 Screen layout

2.4.3 Program control display

SKP
References
DRY
Dry run feedrate
ROV
Rapid traverse override
M01
Programmed stop
M101
Halt at cycle end
DRF
DRF selection
PRT
Program test
FST
Feed stop
2-48
Only functions that have been activated are visible (settable via
"Program control"). The channel status line is displayed irrespective of
the selected menu.
Skip block
/PG/ Programming Guide Fundamentals, Chapter 2
Traverse movements are performed with the feedrate value set in the
setting data "Dry run feedrate". The dry run feedrate function replaces
the programmed travel commands.
The override switch for the feedrate also applies to the rapid traverse
feedrate.
When this function is active, processing of the program is stopped at
every block in which miscellaneous function M01 is programmed.
The message "Stop: M00/M01 active" is then displayed on the screen.
You restart processing with the Cycle Start key. if the function is not
active, then the miscellaneous function M01 (from the part program) is
disregarded.
According to option set.
When the "DRF" function is active, DRF offsets are applied.
In program test mode, set point outputs to the axes and spindles are
disabled. The set point display "simulates" the traverse movements.
The activated feed stop is displayed.
This function is not activated/deactivated under Program Control, but
via the Feed Start/Feed Stop keys on the machine control panel.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
2
03.04
 Siemens AG, 2004. All rights reserved