Dry Run Feedrate For Dry Mode; Starting Angle For Thread Cutting - Siemens SINUMERIK 840D Operator's Manual

5
Parameters Operating Area
5.7 Setting data

5.7.4 Dry run feedrate for DRY mode

Setting
data
Feedrate
DRY

5.7.5 Starting angle for thread cutting

5-184
Function
The feedrate entered here is used in the active program instead of the
programmed feedrate when the function "Dry run feedrate" (program
control) is selected in "Automatic" mode.
Operating sequence
Select softkey "Setting data".
The vertical softkey bar changes.
Select "Feedrate DRY" softkey.
The "Dry run feedrate" window is opened.
Change the dry run feedrate:
Enter a new value.
Function
For thread cutting, a starting position for the master spindle is
displayed as the starting angle. A multiple thread can be cut by
changing the angle when the thread cutting operation is repeated.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
X
Starting point
offset in °
Starting angle
for thread
(setting data)
Z
 Siemens AG, 2004. All rights reserved
5
03.04