Download  Print this page

Display And Modify System Resources - Siemens SINUMERIK 840D Operator's Manual

Computerized numerical control system for machine tools.
Hide thumbs

Advertisement

8
03.04

8.3.4 Display and modify system resources

8.3.5 Communications fault log
Comm.
Log
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Bit6:
Interrupt processing for SPL start called
Bit7:
Interrupt processing for SPL start terminated
Bit9:
NCK cross-checking has been started
Bit10: PLC cross-checking has been started
Bit11: Cyclic SPL checksum checking active
Bit12: All SPL protection features active
Function
You can display the system resources currently in use for the NC and
HMI Embedded areas (utilization display).
Further information
The display is also available in the "Start-up" operating area.
The procedure is described in Chapter 9, Section entitled "Display and
Change System Resources".
Function
Errors occurring in the communication between HMI Embedded and
NCK/PLC are recorded in a communication error log.
You can display this log by pressing the "Comm. Log." key.
The error log file is principally used by the control manufacturer
(Siemens) as a diagnostic tool for communication errors.
The communication error log file can be read out via the RS-232
interface in the "Services" operating area.
Diagnosis Operating Area
8.3 Service display
8
8-287

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: