Protection Zones - Siemens SINUMERIK 840D Operator's Manual

5
Parameters Operating Area
5.7 Setting data
Find next

5.7.7 Protection zones

References
Setting
data
Protection
zones
Protection
Protection
zone + zone −
G17
G18
G19
5-186
If several setting data have the same initial identifier, you can display
other setting data by selecting softkey "Find next".
Change setting data:
Position the cursor bar on the appropriate input field and enter a new
value.
Further information
Data can be edited or not depending on the active access protection
level.
Function
The "Protection zones" function allows you to protect various
elements on the machine, your equipment or the machined workpiece
against incorrect axis motions. You can view up to 10 programmed
protection zones in levels G17, G18 and G19.
/PGA/ Programming Guide, Advanced
Operating sequence
Select softkey "Setting data".
The vertical softkey bar changes.
Select softkey "Protection zones".
The "Working area limitations and protection zones" window opens.
The vertical softkey bar changes again.
Select softkey "Protection zone +" or "Protection zone -".
Up to 10 protection zones are displayed in succession.
Select the plane in which the relevant protection zone is located:
•
Plane G17 (X,Y; positioning direction Z)
•
Plane G18 (Z,X; positioning direction Y)
•
Plane G19 (Y,Z; positioning direction X)
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5
03.04
 Siemens AG, 2004. All rights reserved