Service Drive - Siemens SINUMERIK 840D Operator's Manual

8
03.04

8.3.2 Service drive

References
Service
displays
Service
drive
Drive Drive
+ -
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Function
The information contained in the "Service drive" display is used to
• check the status on enabling and control signals (e.g. pulse
enable, drive enable, motor selection, setpoint parameter set), and
on FDD/MSD operating modes (e.g. setup mode, parking axis)
• display temperature warnings, check the current setpoint/actual-
value display (e.g. position actual-value measuring system 1/2,
speed setpoint, speed actual value)
• check the drive status
• display the current ramp-up phase
• display total error messages (Message ZK1), display the status
messages of the drive (e.g. threshold torque not reached, actual
speed = set speed)
/FB1/D1: Diagnostic tools
Operating sequence
Select the menu headed "Service displays".
The horizontal softkey bars change.
The "Service drive" window displays information about the axis drive
together with axis name and number.
You can page up and down with the "Page" keys.
The service values of the next (+) and the previous (–) drive are
displayed.
Diagnosis Operating Area
8.3 Service display
8
8-283