Download  Print this page

Siemens SINUMERIK 840D Operator's Manual Page 130

Computerized numerical control system for machine tools.
Hide thumbs

Advertisement

5
Parameters Operating Area
5.1 Tool data
References
5-130
The monitoring data apply to both the left-hand and the right-hand
cutting edge of the grinding wheel.
The tool lengths are not automatically compensated when the angle is
altered.
On inclined axis machines the same angle must be specified for the
inclined axis and the inclined wheel.
Offsets that are not required must be assigned the value 0 (= default
when the offset memory is set up).
The tool offsets can be entered not only via the operator panel front
but also via the data input interface.
For programming of compensation data see
/PG/ Programming Guide Fundamentals
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5
03.04
 Siemens AG, 2004. All rights reserved

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: