2
Operation
2.8 Manual mode
2.8.3 Entering a new tool in the list and loading it in the magazine
Entering tool in tool list
-or-
New
Tool
Cutter
3D probe
...
Loading tool to magazine
Load
2.8.4 Starting, stopping, and positioning a spindle manually
Setting the spindle speed
Jog
Cycle Start
2-102
Press the "Offset" key or the "Tool zero" softkey to open the tool
list.
Select a free slot in the tool list and enter a new tool (as described
in Sec. "Tools and tool offsets").
Press the "New Tool" softkey.
Select the desired tool type.
Enter a name for the tool. Enter the tool offsets if applicable.
Press the "Load" softkey if you are using a magazine with variable
location assignment.
If it is a magazine with fixed location assignment, load the tool in the
required magazine location as described in the machine
manufacturer's instruction manual.
Select the "T, S, M" softkey in "Machine Manual" mode.
Enter the spindle speed value of your choice in the "Spindle" input
field.
Press the "Cycle Start" key.
If the spindle is already running the new speed is accepted. If the
spindle is stationary, the value is stored as the setpoint speed. The
spindle remains stationary.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
2
10.04
Siemens AG, 2004. All rights reserved