Siemens SINUMERIK 840D Operator's Manual page 193

5
03.04
Work offset
Basic WO
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Operating sequence
Select softkey "Work offset".
The vertical softkey bar changes.
All defined basic work offsets (global and channel-specific) are
displayed in a table.
The display mode can be changed by softkey (see above).
You can edit the values directly in the table.
Rotations are not possible with global frames, since no geometrical
relationship exists between the axes in this case.
Further information
The work offset must be changed only when the NC program is
stopped. Changes are updated immediately. The work offset values in
the display are updated cyclically.
Parameters Operating Area
5.8 Zero offset
5
5-193