Storing A Program; Enable Workpiece/Program - Siemens SINUMERIK 840D Operator's Manual

6
03.04

6.7.7 Storing a program

Save file

6.7.8 Enable workpiece/program

Change
enable
 Siemens AG, 2004, All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Function
You can save the changes in a program that you have unloaded with
the function "Save file".
Operating sequence
Changes are saved in the file loaded in the editor.
Further information
Please note that the changes to programs stored in the NC memory
take immediate effect.
Function
The program overview indicates whether a workpiece or part program
is enabled.
This means that It may be executed by the control (because it has
already been debugged) when you select softkeys "Select program"
and "Cycle Start".
When a new program is created, it can be enabled automatically. You
can select this in the editor settings.
Operating sequence
To set the enable for a program or abort it, position the cursor on the
desired workpiece or part program in the program overview.
Select softkey "Change enable".
A cross indicating "Enable issued" appears behind the workpiece or
part program.
(x)
Enable issued (program is executable)
( )
No enabling (program must not be executed)
Program Operating Area
6.7 Manage programs
6
6-239