Download  Print this page

Siemens SINUMERIK 840D Operator's Manual Page 57

Computerized numerical control system for machine tools.
Hide thumbs

Advertisement

2
03.04
OK
Abort
Find
Find
next
or
Replace
or
Abort
Save file
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
2.5 General operating sequences
"Go to...":
Enter the block number you are looking for.
If the line being searched for contains an "N" or ":" you are
taken to that block,
If there is no block with the specified number, a message is
output.
Press softkey "OK" or the "Input" key to position the cursor on the
block number/line number of your choice.
The "Go to..." window is closed.
If you abort positioning, the process is stopped and the window
closed.
"Find"
Enter the character string you wish to find.
The string you enter is sought downwards from the current cursor
position, the find result appears as highlighted text.
You can start a new search by pressing softkey "Find next" or the
"Input" key.
Enter the new text with the "Replace" softkey.
The text found is replaced by the "replacement text". The new text is
replaced when you press "Input". Every time you press "Input", a new
find and replace process is started.
If you abort Find + Replace, the process is stopped and the window
closed. You are in "Edit mode" again.
Save file
Changes are saved in the file loaded in the editor.
Further information
Please note that the changes to programs stored in the NC memory
take immediate effect.
Operator Components/Operating Sequences
2
2-57

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: