Activate Work/Zero Offset And Basic Frame Immediately - Siemens SINUMERIK 840D Operator's Manual

5
03.04
9

5.8.4 Activate work/zero offset and basic frame immediately

Machine manufacturer
References
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
CHAN1 AUTO
Parameter
Channel RESET
Program aborted
Settable work offset
Axis
G54 coarse
fine
G55 coarse
fine
G56 coarse
fine
G57 coarse
fine
Tool R Setting
offset data
variable
You can choose a work offset selectively from the overview of work
offsets. Select the appropriate fields with the cursor
and overwrite the fields you want to change with the new value.
Select a new value via the "Select" key (with mirroring).
The work offsets are saved, i.e. transferred to the NC.
Function
The machine data can be set to specify that the work offset and basic
frame can be activated immediately if the part program switches to the
"Reset" state. This also occurs if the part program was first switched
to JOG status.
If the channel is in the "Reset" state, active work offset and basic
frame are not activated until the part program is continued.
Further information
When the function is used in the Reset state, the machine data must
be set such that the settable work offset or basic frame is not reset
when the program switches to Reset.
Please follow the machine tool manufacturer's instructions!
/FB/ K2: Axis Types, Coordinate Systems, Frames
Parameters Operating Area
5.8 Zero offset
MPF.DIR
CHIRON.MPF
ROV
X Y
0.000 0.000
0.000 0.000
0.000 0.000
0.000 0.000
0.000 0.000
0.000 0.000
0.000 0.000
0.000 0.000
Work
User data
offset
5
Axis +
Axis -
Z
Rot./scal.
0.000 mirr.
0.000
0.000
Basic WO
0.000
0.000
Settable
0.000
work offsets
0.000
0.000
Overview
5-191