Machine Control Panels - Siemens SINUMERIK 840D Operator's Manual

2
Operator Components/Operating Sequences

2.2 Machine control panels

2.2

Machine control panels

Standard turning
machines/milling machines
1 EMERGENCY STOP key
2 Operating modes (with
machine functions)
3 Incremental
traverse/Increment
4 Program control
5 Direction key with rapid
traverse override
6 Spindle control
7 Feedrate control
8 Key switch
Machine control panel
OP 032S
2-34
Actions on the machine tool, for example traversing the axes or
program start, can only be initiated via a machine control panel.
The machine tool can either be equipped with a standard machine
control panel from SIEMENS or with a specific machine control panel
from the machine-tool manufacturer.
The machine control panel described in this document is the panel
supplied by SIEMENS. If you are using another machine control
panel, please consult the operating instructions of the machine-tool
manufacturer.
The standard machine control panel from SIEMENS is equipped with
the following operator controls:
4
1 2 3
Machine control panel for turning machines
1 4 2 3
Machine control panel for milling machines
Machine control panel OP 032S
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
03.04
5 6 7
5 6 7
 Siemens AG, 2004. All rights reserved
2
8
8