Create New Tool - Siemens SINUMERIK 802D sl Programming And Operating Manual

4.2

Create new tool

Functionality
The tool offsets consist of various data describing the geometry, the wear and the tool type.
Each tool contains a defined number of parameters, depending on the tool type. Tools are
identified by a number (T number).
Operating sequences (general)
Press the <OFFSET PARAM> key.
This function opens the "Tool list" window which contains a list of the tools created. Use the
cursor keys and the <Page Up>/<Page Down> keys to navigate in this list.
Figure 4-2
The offsets are entered by placing the cursor bar on the tool to be modified and pressing the
<Tool data> softkey.
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Tool list
Setup
4.2 Create new tool
33