8.3.7 Displaying loadable compile cycles
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
If compile cycles are available in the NCK, you can display them in a
separate version display. Besides the current version (name,
extension, type, date, time, length) and the start address (path/NC-
card), the access authorization for "reading, writing, enabling, listing
and deleting" are displayed.
Loadable compile cycles are available for the following software
NCK SW 6.3 and higher
HMI Embedded: (SW 6.5 and higher)
Compile cycles are loaded when you initiate an NCU reset and can be
When you open the "Version" window in the "Service displays" menu,
the "Compile cycles" softkey is displayed.
All loaded files of the type .elf are displayed in the "Version data
compile cycles" overview.
In the "Services" operating area, you can output data via RS-232 C in
the "Manage data" basic screen. Additional storage places, such as
logical drives, are also possible.
Press the "Properties" softkey
The horizontal and vertical softkey menu changes and a "Properties"
window, such as the one below for NC card, appears.
:Loadable compile cycle
Contents: Loadable compile cycle
Version: MCSC Coupling axes MCS
Advance version of compile cycle (Preliminary)
Interface: 001.001@Interfaces=002.000 @TChain=001.000
Current access level:
Diagnosis Operating Area
8.3 Service display