Series Start-Up - Siemens SINUMERIK 840D Operator's Manual

7
03.04

7.5.12 Series start-up

Series
start-up
RS 232 C
user
...
Start
Data in
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Function
You can archive the current software on your machine and import it to
other machines with series start-up.
You can choose which data you want to archive:
•
NCK data with/without compensation data
•
Loadable compile cycles
•
PLC data
If you want to import data to other machines, you should not archive
the compensation data along with other data, because compensation
data is machine specific.
The drive data (contained in the NCK data) are saved in binary
format; i.e. you cannot change the drive data.
You can archive data via the RS-232 interface or archive it to the NC
Card or to other drives connected with the PCU (logical drives).
If you want to archive data via the RS-232 interface, you must set the
"binary" format.
Operating sequence
Press the "ETC" key and then the "Series start-up" softkey.
You can choose which data you want to archive.
You can choose where you want to save the archive.
More
Press "Start" softkey.
Enter the archive name.
The selected data are saved in an archive file.
The archive file can be read in via the "Data in" function.
Services Operating Area
7.5 Main services screen
7
7-277