Changing The Settable Work/Zero Offset (G54 - Siemens SINUMERIK 840D Operator's Manual

5
Parameters Operating Area
5.8 Zero offset
Basic
WO
Settable
work offsets

5.8.3 Changing the settable work/zero offset (G54 ...)

$P_UIFR[]
Coarse offset
Fine offset
Machine manufacturer
Rotation
Scale
Mirroring
Work
offset
Settable
work offsets
5-190
Display other work offsets:
All defined basic work offsets (global and channel-specific) are
displayed in a table.
All defined settable work offsets are displayed in a table where they
can be edited if necessary (select and edit).
Function
This identifier can be used to change a settable zero offset in the
program.
The value of the coarse offset is defined for the relevant axis.
The data limits (absolute) are set for the fine work offset via the
machine data. The fine offset is displayed in the "Settable work offset"
screen.
The work offset is activated via MD.
The basic work offset is activated by MD.
Please follow the machine tool manufacturer's instructions!
The value of the rotation around the respective geometry axis (e.g. X,
Y, Z) can be entered.
Rotation can only be programmed around geometry axes.
The scale factor can be defined for the respective axis.
Mirroring of the relevant axis around the coordinate zero can be
activated and deactivated.
Operating sequence
Select softkey "Work offset".
The vertical softkey bar changes.
The "Settable work offsets" window opens.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5
03.04
 Siemens AG, 2004. All rights reserved